Code: 092-310
Description: CTD Sensor Error (CMYK) Caution Do not run the toner motors for more than a few seconds. The ADC Sensor has detected a density error for the indicated color. This troubleshooting procedure applies to this error.
Causes: • Imaging Unit, PL4.1.21 • Dispense Assembly, PL5.1.1 • Toner Cartridge (CMYK), PL5.1.21~24 • Toner Motor harness, PL5.1.25 • Transfer Belt, PL6.1.7 • Left Side Harness, PL10.4.18 • MCU Board, PL10.7.7
Remedy: 1 Check the Transfer Belt installation. Is the Transfer Belt correctly installed? Go to step 3. Reseat the Transfer Belt. Go to step 2. 2 Does the error still occur when the printer is turned On? Go to step 3. Complete. 3 Check Left Side Harness continuity. Disconnect P/J28 from the MCU Board and P/J281 to the Transfer Belt. Is the harness damaged? Repair or replace the harness (PL10.4.18). Go to step 4. 4 Run the Toner Motor test for the affected color (DO-21, DO-23, DO- 25, DO-27) on. Does the motor rotate? Go to step 5. Go to step 6. 5 Check the Dispense Assembly gear for the indicated color. Is the gear damaged or excessively worn? Repair or replace the gear or Dispense Assembly. Go to step 6. 6 Check MCU Board connectors P/J18 and toner motor connections: • P/J181(Y) • P/J182(M) • P/J191(C) • P/J192(K) Are the connectors secure? Go to step 7. Reconnect the connectors. 7 Check Toner Motor harness continuity. Disconnect P/J18 from the MCU Board and the connection to the indicated toner motor. Is the harness damaged? Repair or replace the harness (PL10.8.7). Go to step 8. 8 Check for +24 V at J18 or J19 on the MCU Board. Is +24 V available at • J18-3 (Y) • J18-8 (M) • J19-4 (C) • J19-9 (K) when the Interlock Switch is closed? Replace the Dispense Assembly. Replace the MCU Board. 9 Reseat the Imaging Unit. Does the error persist? Go to step 10. Complete. 10 Replace the indicated Toner Cartridge. Does the error persist? Replace the Transfer Belt. Complete.