Thương hiệu phân phối chính hãng
Giỏ hàng

Mã lỗi -01 — Xerox Phaser 6130

Code: -01

Description: Insert Yellow/Cyan/Magenta/Black Cartridge The printer does not detect the Toner Cartridge. Non-Xerox Toner, Invalid Yellow/Magenta/Cyan/Black The Toner Cartridge CRUM ID error indicates that a non-Xerox Toner Cartridge is installed. Replace Yellow/Magenta/Cyan/Black The Toner Cartridge (Yellow/Magenta,/Cyan/Black) has reached its end of life. Yellow/Magenta/Cyan/Black Low The Toner Cartridge (Yellow/Magenta,/Cyan/Black) is near its end of life.
Causes: • Toner Cartridge (Y/M/C/K), PL5.1.21-24 • MCU Board, PL8.2.13
Remedy: 1 Check the Toner Cartridge for correct installation. Is the Toner Cartridge correctly installed? Go to step 3. Go to step 2. 2 Reseat the Toner Cartridge. Make sure the lock key is in the lock position. Does the error still occur? Go to step 3. Complete. 3 Replace the Toner Cartridge. Does the error still occur? Go to step 4. Complete. 4 Check the Toner CRUM Harness for continuity 1. Disconnect J31 from the MCU Board. 2. Disconnect J311 (Y), J312 (M), J313 (C) or J314 (K) from the connector CRUM. Is each cable of J31 <=> J311, J312, J313 or J314 continuous? Go to step 5. Replace the Dispenser Assembly 5 Reseat plugs and jacks on the MCU Board. Does the error still occur when the power is turned OFF and ON? Go to step 6. Complete. 6 Measure the voltage at P31-3 <=> Ground. Is the voltage approximately +3.3VDC? Replace the Dispenser Assembly Replace the MCU Board.

← Xem tất cả mã lỗi Xerox Phaser 6130

Đăng ký nhận bản tin Đăng ký nhận bản tin Đăng ký nhận bản tin Đăng ký nhận bản tin
Đăng ký nhận bản tin
Nhận ưu đãi sớm nhất khi chương trình diễn ra

Đăng ký nhận bản tin

Việc cho phép sử dụng cookie sẽ giúp cải thiện trải nghiệm của bạn trên trang web này. Chính sách cookie