Thương hiệu phân phối chính hãng
Giỏ hàng

Mã lỗi -04 — Xerox Phaser 6130

Code: -04

Description: Low Density Yellow/Magenta/Cyan/Black Cartridge
Causes: • Dispenser Assy, PL5.1.1 • Toner Cartridge (Y,M,C,K), PL5.1.(21,22,23,24) • Transfer Unit Assy, PL6.1.7 • MCU Board, PL8.2.13 • Imaging Unit, PL4.1.21
Remedy: 1 Use CWIS to determine the amount of toner remaining. Does CWIS report very little toner remaining? Replace the Toner Cartridge, then go to step 2. Go to step 3. 2 Does the error still occur when the power is turned OFF and ON? Go to step 3. Complete 3 Check the Y, M, C, or K Toner Motor: Service Mode > Engine Diag > Motor Test > (Yellow, Magenta, Cyan, Black) Toner Motor. Does the Toner Motor function normally? During this check, defeat the Front Cover interlock switch. Go to step 4. Go to step 5. 4 Check the Dispenser Assy gears for shape and operation. Are the shape and operation of the gears of the DISPENSER ASSY normal? Go to step 9. Replace the Dispenser Assembly. 5 Check the connectors between the MCU Board and Dispenser Motor Assembly. Are P/J18 and P/J181 connected correctly? Go to step 7. Reconnect connector(s) P/ J18 and/or P/ J181 securely, then go to step 6. 6 Does the error still occur when the power is turned OFF and ON? Go to step 7. Complete 7 Check the Toner Motor Harness Assembly for continuity Disconnect J18 from the MCU Board for the Y or M Toner Motors, or J19 for the C or K Toner Motors. Disconnect J181 from the Y Motor, or J182 from the M Motor; or disconnect J191 for the C Motor, or J192 for the K Motor Is each cable of J18 <=> J181/J182 or J19 <=> J191/J192 continuous? Go to step 8. Replace the Dispenser Assembly. 8 Check the power to the Toner Motors Disconnect J18 and/or J19 from the MCU Board. On the MCU Board, is the voltage across P18-3, P18-8, P19-4 or P19-9 <= > ground about +24 VDC when the interlock switch (HARN ASSY INTERLOCK) is pushed. Replace the Dispenser Assembly. Replace the MCU Board. 9 Replace the Toner Cartridge (Y, M, C, or K), and check that the lock key is in the lock position. Does the error still occur when the power is turned OFF and ON? Go to step 10. Complete 10 Replace the Imaging Unit. Does the error still occur when the power is turned OFF and ON? Replace the Transfer Unit. Complete

← Xem tất cả mã lỗi Xerox Phaser 6130

Đăng ký nhận bản tin Đăng ký nhận bản tin Đăng ký nhận bản tin Đăng ký nhận bản tin
Đăng ký nhận bản tin
Nhận ưu đãi sớm nhất khi chương trình diễn ra

Đăng ký nhận bản tin

Việc cho phép sử dụng cookie sẽ giúp cải thiện trải nghiệm của bạn trên trang web này. Chính sách cookie