Thương hiệu phân phối chính hãng
Giỏ hàng

Mã lỗi -07 — Xerox Phaser 6130

Code: -07

Description: Load Manual Feed No paper detected at Manual Feed Slot.
Causes: Left Side Harness Assy (PL3.1.18) Photo Sensor (PL3.2.13) SSI Actuator (PL3.2.14) MCU Board (PL8.2.13)
Remedy: 1 Check the paper for loading and setting Check that the paper in use meets the print job requirements Does the error still occur after reloading the paper and changing the paper settings that the print job requires? Go to step 2. Complete 2 Reset the side guides. Does the error still occur when printing? Go to step 3. Complete 3 Insert a sheet of paper that is suitable for the print data and the paper settings into the Manual Feed Slot. Does the error still occur when printing? Go to step 4. Complete 4 Check the SSI Actuator for shape and operation Are the shape and operation of the SSI Actuator normal? Go to step 5. Reseat the SSI Actuator. If broken or damaged, replace the SSI Actuator. 5 Check the Manual Feed Sensor (Photo Sensor) for operation. Perform the Manual Feed Sensor test: Service Mode > Engine Diag > Sensor Test > Manual Feed Sensor Does the number on the screen increase by one, when the SSI Actuator is operated? Replace the MCU Board. Go to step 6. 6 Check the connectors of the Photo Sensor (SSI No Paper Sensor) for connection Check the connections between the MCU Board and Photo Sensor (SSI No Paper Sensor). Are P/J23 and P/J233 connected correctly? Go to step 8. Reconnect the connector(s) P/ J23 and/or P/ J233 correctly, then go to step 7. 7 Does the error still occur when printing? Go to step 8. Complete 8 Check the Left Side Harness Assy for continuity Disconnect J23 from the MCU Board. Disconnect J233 from the Photo Sensor. Is each cable of J23 <=> J233 continuous? Go to step 9. Replace the Feeder Assy or Left Side Harness Assy. 9 Check the power to the Photo Sensor Disconnect J23 from the MCU Board. Is the voltage across P23-6pin <=> ground on the MCU Board, about +3.3 VDC? Go to step 10. Replace the MCU Board. 10 Check the Photo Sensor for operation Check the voltage across J23-8pin <=> ground on the MCU Board. Does the voltage change, when the SSI Actuator is operated? Replace the MCU Board. Replace the Feeder Assy.

← Xem tất cả mã lỗi Xerox Phaser 6130

Đăng ký nhận bản tin Đăng ký nhận bản tin Đăng ký nhận bản tin Đăng ký nhận bản tin
Đăng ký nhận bản tin
Nhận ưu đãi sớm nhất khi chương trình diễn ra

Đăng ký nhận bản tin

Việc cho phép sử dụng cookie sẽ giúp cải thiện trải nghiệm của bạn trên trang web này. Chính sách cookie