Thương hiệu phân phối chính hãng
Giỏ hàng

Mã lỗi 042-325 — Xerox Phaser 6130

Code: 042-325

Description: Motor Error The Main Motor has failed.
Causes: • MCU Board, PL8.2.13 • Main Drive Assembly, PL8.1.2
Remedy: 1 Check the Imaging Unit for correct installation. Is the Imaging Unit seated correctly? Go to step 3. Reseat the Imaging Unit and cycle the power. Go to step 2. 2 Does the error still occur? Go to step 3. Complete. 3 1. Close the Front Cover. 2. Perform the Main Motor test: Service Mode > Engine Diag > Motor Test > Main Motor FULL2. Does the Motor operate properly? Replace the MCU Board. Go to step 4. 4 Check the wiring harness connectors P/J21 and P/J211 between the MCU Board and the Main Drive. Are the connectors securely connected? Go to step 6. Reconnect the connectors. Go to step 5. 5 Turn the power Off, then On. Does the error still occur? Go to step 6. Complete. 6 Check the Main Drive for correct installation. Is the Main Drive securely installed? Go to step 8. Reseat the Main Drive. Go to step 7. 7 Does the error still occur? Go to step 8. Complete. 8 Check the Main Drive signal. 1. Disconnect P/J21 on the MCU Board. 2. Are there +24 V across ground <=> J21-2/J21-4 when the Interlock Switch is activated? Replace the Main Drive Assembly. Replace the MCU Board.

← Xem tất cả mã lỗi Xerox Phaser 6130

Đăng ký nhận bản tin Đăng ký nhận bản tin Đăng ký nhận bản tin Đăng ký nhận bản tin
Đăng ký nhận bản tin
Nhận ưu đãi sớm nhất khi chương trình diễn ra

Đăng ký nhận bản tin

Việc cho phép sử dụng cookie sẽ giúp cải thiện trải nghiệm của bạn trên trang web này. Chính sách cookie