Thương hiệu phân phối chính hãng
Giỏ hàng

Mã lỗi 042-372 — Xerox Phaser 6130

Code: 042-372

Description: K Mode Sol Error K Mode Solenoid (Color Mode Switching Solenoid) error is detected.
Causes: • Feed Drive Assembly (Drive Assy PH), PL7.1.4 • MCU Board, PL8.2.13
Remedy: 1 Reseat the Imaging Unit. Does the error still occur when the power is turned OFF and ON? Go to step 2. Complete 2 Perform the K Mode Solenoid test: Service Mode > Motor Test > K Mode Solenoid. During this check, close the Front Cover. Does the solenoid click when the K Mode Solenoid check is performed? Go to step 7. Go to step 3. 3 Check the connection between the MCU Board and K Mode Solenoid. Is P/J24 connected securely? Go to step 5. Reconnect the connector P/J24 correctly, then go to step 4. 4 Does the error still occur when the power is turned OFF and ON? Go to step 5. Complete 5 Check the power to the K Mode Solenoid Disconnect J24 from the MCU Board. Is the voltage across P24-1pin <=> ground on the MCU Board, about +24 VDC when the Interlock Switch (HARN ASSY INTERLOCK) is pushed? Go to step 6. Replace the MCU Board. 6 Check the K Mode Solenoid for resistance Disconnect P/J24 from the MCU Board. Is the resistance across J24-1 and J24-2 about 80 to 110-ohm? Replace the MCU Board. Replace the Feed Drive Assembly. 7 Check that the Feed Drive Assembly is properly installed. If not, install correctly. Does the error still occur when the printer is powered on? Go to step 8 Complete 8 Check the connections between the MCU Board and K Mode Sensor. Are P/J26 and P/J261 connected securely? Go to step 10. Reconnect the connector(s) P/ J26 and/or P/ J261 correctly, then go to step 9. 9 Does the error still occur when the power is turned OFF and ON? Go to step 10. Complete 10 1. Disconnect J26 from the MCU Board. 2. Measure the voltage across P26-1 <=> ground on the MCU Board. Is the voltage about +3.3 VDC? Go to step 11. Replace the MCU Board. 11 1. Remove the Feed Drive Assembly from the printer, but let P/J261 and P/J24 remain connected. 2. Perform the K Mode Sensor test: Service Mode > Sensor Test > K Mode Sensor. During this check, close the Front Cover. Does the voltage change, when a piece of paper is inserted into the gap of the K Mode Sensor? Replace the MCU Board. Replace the Feed Drive Assembly.

← Xem tất cả mã lỗi Xerox Phaser 6130

Đăng ký nhận bản tin Đăng ký nhận bản tin Đăng ký nhận bản tin Đăng ký nhận bản tin
Đăng ký nhận bản tin
Nhận ưu đãi sớm nhất khi chương trình diễn ra

Đăng ký nhận bản tin

Việc cho phép sử dụng cookie sẽ giúp cải thiện trải nghiệm của bạn trên trang web này. Chính sách cookie