Code: 092-310
Description: CTD Sensor Error/CTD Sensor/Check Unit
Causes: • Left Side Harness, PL3.1.18 • MCU Board, PL8.2.13 • Transfer Unit, PL6.1.7
Remedy: 1 Check the ADC Sensor Window Open the Front Cover. Is the ADC Sensor window dirty? Go to step 2. Go to step 3. 2 1. Turn off the power, and gently wipe the ADC Sensor window with a clean dry cloth or cotton swab. 2. After wiping the window, close the Front Cover. Does the error still occur when the power is turned OFF and ON? Go to step 3. Complete. 3 Check the Transfer Unit belt. Open the Front Cover. Is there any damage on the belt surface? Replace the Transfer Unit. Go to step 4. 4 Check the connections between the MCU Board and Transfer Unit. Are both P/J28 and P/J281 connected correctly? Go to step 6. Reconnect P/ J28 and/or P/ J281 correctly, then go to step 5. 5 Does the error still occur when the power is turned OFF and ON? Go to step 6. Complete 6 Check the Left Side Harness for continuity 1. Disconnect J281 from the Transfer Unit. 2. Disconnect J28 from the MCU Board. Is each cable of J281 <=> J28 continuous? Go to step 7. Replace the Feeder Assy or Left Side Harness Assy. 7 Check the power to the ADC Sensor 1. Disconnect J28 from the MCU Board. 2. Measure the voltage between P28-1 and ground. Does the voltage measure about +5 VDC? Replace the Transfer Unit Replace the MCU Board