Code: 016-790
Description: Network Not Ready Error The network is not ready. The following troubleshooting procedure applies to this error.
Causes: • Scanner Controller Board, PL9.1.1 • Image Processor Board, PL9.1.20 • Multi-Protocol Card, PL9.1.23
Remedy: 1 1. Check the network connection using ping command. 2. Does the printer connect to the network? Go to step 2. Go to step 5. 2 1. Check the Address Book setting: System > Admin Menu > Address Book > Speed Dial/Group Dial. 2. Is the Address Book setting correct? Go to step 3. Set the correct Address Book information. 3 1. Check the printer specification. 2. Does the printer specification meet the server specification? Go to step 4. Change the server. 4 1. Check the Scanner Controller Board for correct installation. Reseat the Scanner Controller Board. 2. Does the error still occur when connecting to the server? Replace the Scanner Controller Board. Complete. 5 1. Check the network connection. Reseat the network connector. 2. Does the error still occur? Go to step 6. If an MPC Card is not installed, go to step 7. Complete. 6 1. Check the MPC Card for correct installation. Reseat the MPC Card. 2. Does the error still occur when connecting to the server? Go to step 7. Complete. 7 1. Check the network setting: System > Admin Menu > Network Settings. 2. Is the printer network setting correct? Go to step 8. Change the Network Setting information. 8 1. Check the Image Processor Board for correct installation. Reseat the Image Processor Board. 2. Does the error still occur when connecting to the server? Replace the Image Processor Board. Complete.