Thương hiệu phân phối chính hãng
Giỏ hàng

Mã lỗi 024-963 — Xerox Phaser 6180

Code: 024-963

Description: Load Tray 1 (MPT) (No Suitable Paper) The type or size of paper mismatched or Tray 1 (MPT) is empty. The following troubleshooting procedure applies to this error.
Causes: • Tray 1 (MPT) Actuator, PL2.1.24 • Tray 1 (MPT) Feed Roll, PL3.1.10 • Feeder Unit, PL3.2.1 • MCU Board, PL9.2.13 • Right Side Harness, PL10.1.12
Remedy: 1 1. Check the paper size. 2. Does the paper size meet specifications? Go to step 2. Replace the paper with the correct specifications. 2 1. Check the paper size setting. 2. Does the paper match with the settings on the printer Control Panel? Go to step 3. Correct the paper settings on the printer Control Panel. Go to step 3. 3 1. Check the paper type. • Paper in the tray • Paper type setting in the Control Panel • Paper type of the printing job 2. Are the paper types the same? Go to step 4. Correct the paper type setting on the printer Control Panel. 4 1. Check the MPT Actuator for operation. 2. Does the Actuator operate smoothly? Go to step 5. Replace the Tray 1 (MPT) Actuator. 5 1. Perform the Tray 1 (MPT) No Paper test: Service Mode > Printer Diag > Engine Diag > Sensor Test > MPT No Paper. 2. Does the number on the Control Panel increase by 1 when the Actuator is activated? Replace the MCU Board. Go to step 6. 6 1. Check the wiring harness connectors P/J27, P/J275, and P/ J2751 between the Tray 1 No Paper Sensor and the MCU Board. 2. Are the connectors securely connected? Go to step 6. Reconnect the connectors. Go to step 6. 7 Check the Right Side Harness for continuity. 1. Disconnect P/J27 and P/J275. 2. Check continuity between P/J27 <=> P/J275. Go to step 7. Replace the Right Side Harness. 8 Check the Tray 1 (MPT) NPP Harness for continuity. 1. Disconnect P/J275 and P/J2751. 2. Check continuity between P/J275 <=> P/J2751. Go to step 8. Replace the MCU Board. 9 Check the Tray 1 No Paper Sensor for operation. 1. Measure the voltage across ground <=> J27-B1 pin. 2. Does the voltage change when the Tray 1 No Paper Sensor is activated? Replace the MCU Board. Replace the Tray 1 No Paper Sensor.

← Xem tất cả mã lỗi Xerox Phaser 6180

Đăng ký nhận bản tin Đăng ký nhận bản tin Đăng ký nhận bản tin Đăng ký nhận bản tin
Đăng ký nhận bản tin
Nhận ưu đãi sớm nhất khi chương trình diễn ra

Đăng ký nhận bản tin

Việc cho phép sử dụng cookie sẽ giúp cải thiện trải nghiệm của bạn trên trang web này. Chính sách cookie