Code: 042-700, 142-700
Description: Printer Too Hot The printer is too hot. The following troubleshooting procedure applies to this error. • Chain Link 042-700: Printer Too Hot (IOT Over Heat Stop) • Chain Link 142-700: Printer Too Hot (IOT Over Heat Forced Half Speed)
Causes: • Feeder Assembly, PL3.2.1 • MCU Board, PL9.2.13 • Humidity Harness, PL10.1.15
Remedy: 1 1. Check the room temperature. 2. Is the room temperature over 32° C? Adjust the room temperature to less than 32° C. Go to step 2. 2 Did the user print large print jobs? Go to step 6. Go to step 3. 3 1. Check the MCU Board for correct installation. Reseat the MCU Board. 2. Does the error still occur when printing? Go to step 4. Complete. 4 Check the Humidity Harness for continuity. 1. Disconnect P/J26 from the MCU Board. 2. Disconnect P/J261 from the Humidity/Temperature Sensor. 3. Check continuity between P/J26 <=> P/J261. Go to step 5. Replace the Humidity Harness. 5 1. Replace the MCU Board. 2. Does the error still occur when printing? Replace the Feeder Assembly. Complete. 6 Does the error still occur after the printer has cooled down for about five minutes? Go to step 3. Complete.