Thương hiệu phân phối chính hãng
Giỏ hàng

Mã lỗi 077-343 — Xerox Phaser 6180

Code: 077-343

Description: Motor Error (Tray 2) The Tray 2 Motor has failed. The following troubleshooting procedure applies to this error.
Causes: • Feeder Unit Kit, PL3.2.1 • Feed Drive Assembly, PL8.1.7 • MCU Board, PL9.2.13 • Right Side Harness, PL10.1.12 •
Remedy: 1 1. Check the Rubber Registration Roller for rotation. 2. Does the Roller rotate smoothly? Go to step 2. Replace the Feeder Unit. 2 1. Check the wiring harness connectors P/J25 and P/J251 between the MCU Board and the Drive Assembly. 2. Are the connectors securely connected? Go to step 3. Reconnect the connectors. Go to step 3. 3 1. Perform Tray 2 Motor test: Service Mode > Printer Diag > Engine Diag > Motor Test > Tray 2 Motor. During the test, close the Front Cover. 2. Does the Motor operate properly? Replace the MCU Board. Go to step 4. 4 1. Check the Feed Drive Assembly for correct installation. 2. Is the Feed Drive Assembly correctly installed? Go to step 5. Reseat the Feed Drive Assembly. Go to step 5. 5 Does the error still occur when the printer is turned On? Go to step 6. Complete. 6 Check the Right Side Harness for continuity. 1. Disconnect P/J25 from the MCU Board. 2. Disconnect P/J251 from the Feed Drive Assembly. 3. Check continuity between P/J25 <=> P/J251. Go to step 7. Replace the Right Side Harness. 7 Check the Drive Assembly signal. 1. Disconnect P/J25 from the MCU Board. 2. Is there +24 V across ground <=> J25-1/J25-2 pin on the MCU Board when the Interlock Switch is activated? Replace the Feed Drive Assembly. Replace the MCU Board.

← Xem tất cả mã lỗi Xerox Phaser 6180

Đăng ký nhận bản tin Đăng ký nhận bản tin Đăng ký nhận bản tin Đăng ký nhận bản tin
Đăng ký nhận bản tin
Nhận ưu đãi sớm nhất khi chương trình diễn ra

Đăng ký nhận bản tin

Việc cho phép sử dụng cookie sẽ giúp cải thiện trải nghiệm của bạn trên trang web này. Chính sách cookie