Code: 093-970 ... 093-973
Description: Insert Print Cartridge (Yellow/Cyan/Magenta/Black) The printer does not detect the Print Cartridge. The following troubleshooting procedure applies to these errors. • Chain Link 093-970: Insert Yellow Cartridge • Chain Link 093-971: Insert Magenta Cartridge • Chain Link 093-972: Insert Cyan Cartridge • Chain Link 093-973: Insert Black Cartridge
Causes: • Print Cartridge Sensor, PL5.1.6 • Print Cartridge (Y/M/C/K), PL5.1.17-20 • MCU Board, PL9.2.13 • Toner Sensor Harness, PL10.1.7
Remedy: 1 1. Check the Print Cartridge for correct installation. 2. Is the Print Cartridge correctly installed? Go to step 3. Reseat the Print Cartridge 2 Does the error still occur? Go to step 3. Complete. 3 1. Replace the Print Cartridge. 2. Does the error still occur? Go to step 4. Complete. 4 1. Perform the CRU Sensor test: Service Mode > Printer Diag > Engine Diag > Sensor Test > CRU Sensor. • Yellow CRU Sensor • Magenta CRU Sensor • Black CRU Sensor • Cyan CRU Sensor 2. Does the number on the Control Panel increase by 1 when the Print Cartridge is reseated? Replace the MCU Board. Go to step 5. 5 1. Check the Toner Sensor wiring harness connectors between the Print Cartridge Sensor and the MCU Board. • Yellow: P/J19 and P/J191 • Magenta: P/J19 and P/J192 • Black: P/J19 and P/J193 • Cyan: P/J19 and P/J194 2. Are the connectors securely connected? Go to step 6. Reconnect the connectors. Go to step 6. 6 Does the error still occur? Go to step 7. Complete. 7 Check the Toner Sensor Harness for continuity. 1. Disconnect P/J Harnesses from the MCU Board and the Print Cartridge Sensor. • Yellow: P/J19 and P/J191 • Magenta: P/J19 and P/J192 • Black: P/J19 and P/J193 • Cyan: P/J19 and P/J194 2. Check continuity between P/J connectors: • Yellow: P/J19 <=> P/J191 • Magenta: P/J19 <=> P/J192 • Black: P/J19 <=> P/J193 • Cyan: P/J19 <=> P/J194 Go to step 8. Replace the Toner Sensor Harness. 8 Check the Print Cartridge Sensor signal. 1. Disconnect P/J19 from the MCU Board. 2. Is there +3.3 V across the Toner Sensor Harness? • Yellow: J19-1 pin <=> J19-2 pin • Magenta: J19-4 pin <=> J19-5 pin • Black: J19-7 pin <=> J19-8 pin • Cyan: J19-10 pin <=> J19-11 pin Go to step 9. Replace the MCU Board. 9 Check the Print Cartridge Sensor for operation. 1. Measure the voltage across: • Ground <=> P/J19-3 pin (Yellow) • Ground <=> P/J19-6 pin (Magenta) • Ground <=> P/J19-9 pin (Black) • Ground <=> P/J19-12 pin (Cyan) 2. Does the voltage change when the paper is inserted into the sensor detecting point? Replace the MCU Board. Replace the Print Cartridge Sensor: • Black • Yellow/ Magenta/Cyan