Code: 010-317
Description: Insert Fuser The printer does not detect the presence of the Fuser. The following troubleshooting procedure applies to this error. Warning The Fuser may be hot. Turn the printer power Off and allow at least 5 minutes for the Fuser to cool before removing the Fuser.
Causes: • Fuser, PL6.1.10 • MCU Board, PL9.2.13 • LVPS, PL9.2.14 • LVPS Harness, PL10.1.3 • Fuser Harness, PL10.1.5
Remedy: 1 1. Check the Fuser for correct installation. 2. Is the Fuser correctly installed? Go to step 2. Reseat the Fuser. Go to step 2. 2 Does the error still occur when the printer is turned On? Go to step 3. Complete. 3 1. Check the wiring harness connectors P/J17, P/J171, P/J47, P/ J501, and P/J14 between the MCU Board and the Fuser Unit. 2. Are the connectors securely connected? Go to step 4. Reconnect the connectors. 4 Check the Fuser Harness for continuity. 1. Disconnect P/J17 from the MCU Board. 2. Disconnect P/J171 from the Fuser Unit. 3. Disconnect P/J47 from the LVPS. 4. Check continuity between P/J17 and P/J47 <=> P/J171. Go to step 5. Replace the Fuser Harness. 5 Check the LVPS Harness for continuity. 1. Disconnect P/J501 from the LVPS. 2. Disconnect P/J14 from the MCU Board. 3. Check continuity between P/J501 <=> P/J14. Go to step 6. Replace the LVPS Harness. 6 1. Replace the Fuser. 2. Does the error still occur? Go to step 7. Complete. 7 1. Replace the LVPS. 2. Does the error still occur when the printer is turned On? Replace the MCU Board. Complete.