Thương hiệu phân phối chính hãng
Giỏ hàng

Mã lỗi 010-359 — Xerox Phaser 6180 MFP

Code: 010-359

Description: Fuser CRUM ID Error The Fuser CRUM ID error is detected. The following troubleshooting procedure applies to this error. Warning The Fuser may be hot. Turn the printer power Off and allow at least 5 minutes for the Fuser to cool before removing the Fuser.
Causes: • Fuser, PL6.1.10 • MCU Board, PL9.2.13 • Fuser Harness, PL10.1.5
Remedy: 1 1. Check the Fuser for correct installation. Reseat the Fuser. 2. Does the error still occur when the printer is turned On? Go to step 2. Complete. 2 1. Check the Fuser type. 2. Is the Fuser for the Phaser 6180MFP? Go to step 3. Complete. 3 Check the Fuser Harness for continuity. 1. Disconnect P/J17 from the MCU Board. 2. Disconnect P/J171 from the Fuser Unit. 3. Check continuity between P/J17 <=> P/ J171. Go to step 4. Replace the Fuser Harness. 4 1. Replace the Fuser. 2. Does the error still occur when the printer is turned On? Replace the MCU Board. Complete.

← Xem tất cả mã lỗi Xerox Phaser 6180 MFP

Đăng ký nhận bản tin Đăng ký nhận bản tin Đăng ký nhận bản tin Đăng ký nhận bản tin
Đăng ký nhận bản tin
Nhận ưu đãi sớm nhất khi chương trình diễn ra

Đăng ký nhận bản tin

Việc cho phép sử dụng cookie sẽ giúp cải thiện trải nghiệm của bạn trên trang web này. Chính sách cookie