Thương hiệu phân phối chính hãng
Giỏ hàng

Mã lỗi 010-397 — Xerox Phaser 6180 MFP

Code: 010-397

Description: Fuser Error The Fuser temperature regulation has failed. The following troubleshooting procedure applies to this error. Warning The Fuser may be hot. Turn the printer power Off and allow at least 5 minutes for the Fuser to cool before removing the Fuser.
Causes: • Fuser, PL6.1.10 • MCU Board, PL9.2.13 • LVPS, PL9.2.14 • LVPS Harness, PL10.1.3 • Fuser Harness, PL10.1.5
Remedy: 1 1. Check the Fuser for correct installation. 2. Is the Fuser correctly installed? Go to step 2. Reseat the Fuser. Go to step 2. 2 Does the error still occur when the printer is turned On? Go to step 3. Complete. 3 1. Check the wiring harness connectors P/ J17, P/J171, P/J47, P/J501, and P/J14 between the MCU Board and the Fuser Unit. 2. Are the connectors securely connected? Go to step 4. Reconnect the connectors. 4 Check the Fuser Harness for continuity. 1. Disconnect P/J17 from the MCU Board. 2. Disconnect P/J171 from the Fuser Unit. 3. Disconnect P/J47 from the LVPS. 4. Check continuity between P/J17 and P/ J47 <=> P/J171. Go to step 5. Replace the Fuser Harness. 5 Check the LVPS Harness for continuity. 1. Disconnect P/J501 from the LVPS. 2. Disconnect P/J14 from the MCU Board. 3. Check continuity between P/J501 <=> P/ J14. Go to step 6. Replace the LVPS Harness. 6 1. Replace the Fuser. 2. Does the error still occur? Go to step 7. Complete. 7 1. Replace the LVPS. 2. Does the error still occur when the printer is turned On? Replace the MCU Board. Complete.

← Xem tất cả mã lỗi Xerox Phaser 6180 MFP

Đăng ký nhận bản tin Đăng ký nhận bản tin Đăng ký nhận bản tin Đăng ký nhận bản tin
Đăng ký nhận bản tin
Nhận ưu đãi sớm nhất khi chương trình diễn ra

Đăng ký nhận bản tin

Việc cho phép sử dụng cookie sẽ giúp cải thiện trải nghiệm của bạn trên trang web này. Chính sách cookie