Description: Network Not Ready, Scan Aborted Error The scan job has been aborted due to network not ready. The following troubleshooting procedure applies to this error.
Causes: • Image Processor Board, PL9.1.20
Remedy: 1 1. Check the network setting using a PC. 2. Is the setting correct? Go to step 2. Set the correct network information. 2 1. Check the network setting: System > Admin Menu > Network Settings. 2. Is the printer network setting correct? Go to step 3. Set the correct network settings. 3 1. Check the Protocol setting: System > Admin Menu > Network Settings > Protocol > SMB TCP/IP? 2. Is SMB TCP/IP disabled? Set SMB TCP/I/ P to Enable. Go to step 4. 4 1. Check the Image Processor Board for correct installation. Reseat the Image Processor Board. 2. Does the error still occur when the printer power is turned On? Replace the Image Processor Board. Complete.