Description: MCU Firmware Error Firmware error has been detected. The following troubleshooting procedure applies to this error.
Causes: • MCU Board, PL9.2.13
Remedy: 1 1. Turn the printer power Off and back On. 2. Does the error still occur? Go to step 2. Complete. 2 1. Check the firmware version: System > Information Pages > Configuration. 2. Does the firmware have the correct version? Go to step 3. Update the firmware. 3 1. Reseat the MCU Board. 2. Does the error still occur? Go to step 4. Complete. 4 1. Replace the MCU Board. 2. Does the error still occur when the printer is turned On? Refer to “Electrical Noise” on page 4-108, Troubleshooting chapter. Complete.