Description: Insert Tray 2 The Tray 2 Size Switch indicates that Tray 2 is not installed. The following troubleshooting procedure applies to these errors. • Chain Link 024-946: Insert Tray 2 (Tray Detached) • Chain Link 077-912: Insert Tray 2 (Upper Cassette Detached)
Causes: • Tray 2 Size Switch, PL7.1.18 • MCU Board, PL9.2.13 • Right Side Harness, PL10.1.12
Remedy: 1 1. Check the tray for correct installation. 2. Is Tray 2 correctly installed? Go to step 3. Reseat Tray 2. 2 Does the error still occur when the printer is turned On? Go to step 3. Complete. 3 1. Perform the Tray 2 Paper Size test: Service Mode > Printer Diag > Engine Diag > Sensor Test > Tray2 Paper Size. 2. Does the switch operate properly? Complete. Go to step 4. 4 Check the Right Side Harness for continuity. 1. Disconnect P/J23 from the MCU Board. 2. Disconnect P/J231 from the Size Switch Assembly. 3. Check continuity between P/J23 <=> P/J231. Go to step 5. Replace the Right Side Harness. 5 1. Replace the Tray 2 Size Switch. 2. Does the error still occur when the printer is turned On? Replace the MCU Board. Complete.