Thương hiệu phân phối chính hãng
Giỏ hàng

Mã lỗi 024-958 — Xerox Phaser 6180 MFP

Code: 024-958

Description: Load Tray 1 (MPT) (Paper Mismatch) The paper size mismatch is detected in Tray 1 (MPT). The following troubleshooting procedure applies to this error.
Causes: • Tray 1 (MPT) Feed Roll, PL3.1.10 • Feeder Unit, PL3.2.1 • Registration Sensor, PL3.2.30 • Registration Sensor Harness, PL3.2.37 • Size Switch, PL7.1.18 • MCU Board, PL9.2.13 • Right Side Harness, PL10.1.12
Remedy: 1 1. Check the paper size. 2. Does the paper size meet specifications? Go to step 2. Replace the paper with the correct specifications. 2 1. Check the paper size setting. 2. Does the paper match with the settings on the printer Control Panel? Go to step 4. Correct the paper settings on the printer Control Panel. Go to step 3. 3 Does the error still occur when printing? Go to step 4. Complete. 4 1. Perform the Registration Sensor test: Service Mode > Printer Diag > Engine Diag > Sensor Test > Regi Sensor. 2. Does the number on the Control Panel increase by 1 when the Actuator of the Registration Sensor is activated? Replace the MCU Board. Go to step 5. 5 1. Check the wiring harness connectors P/J23, P/J232, and P/ J2322 between the MCU Board and the Registration Sensor. 2. Are the connectors securely connected? Go to step 6. Reconnect the connectors. 6 Check the Registration Sensor Harness for continuity. 1. Disconnect P/J232 from the Right Side Harness. 2. Disconnect P/J2322 from the Registration Sensor. 3. Check continuity between P/J232 <=> P/J2322. Go to step 7. Replace the Registration Sensor Harness. 7 Check the Right Side Harness for continuity. 1. Disconnect P/J23 from the MCU Board. 2. Disconnect P/J232 from the Registration Sensor Harness. 3. Check continuity between P/J23 <=> P/J232. Go to step 8. Replace the Right Side Harness. 8 Check the Registration Sensor for continuity. 1. Disconnect P/J23 from the MCU Board. 2. Is there +3.3 V across ground <=> J23-8 pin? Go to step 9. Replace the MCU Board. 9 Check the Registration Sensor signal. 1. Measure the voltage across ground <=> J23-10 on the MCU Board. 2. Does the voltage change when the Actuator of the Registration Sensor is activated? Replace the MCU Board. Replace the Feeder Unit. Go to step 10.

← Xem tất cả mã lỗi Xerox Phaser 6180 MFP

Đăng ký nhận bản tin Đăng ký nhận bản tin Đăng ký nhận bản tin Đăng ký nhận bản tin
Đăng ký nhận bản tin
Nhận ưu đãi sớm nhất khi chương trình diễn ra

Đăng ký nhận bản tin

Việc cho phép sử dụng cookie sẽ giúp cải thiện trải nghiệm của bạn trên trang web này. Chính sách cookie