Code: 042-325
Description: Main Motor Error The Main Motor has failed. The following troubleshooting procedure applies to this error.
Causes: • Transfer Unit, PL4.1.1 • Print Cartridge (K), PL5.1.17 • Fuser, PL6.1.10 • Main Drive, PL8.1.2 • MCU Board, PL9.2.13 • Right Side Harness, PL10.1.12
Remedy: 1 1. Check the Transfer Unit, Fuser, and Black Print Cartridge for correct installation. 2. Are the parts correctly installed? Go to step 3. Reseat the Transfer Unit, Fuser, and Black Print Cartridge. 2 Does the error still occur when the printer is turned On? Go to step 3. Complete. 3 1. Check the wiring harness connectors P/J21 and P/J211 between the MCU Board and the Main Drive. 2. Are the connectors securely connected? Go to step 5. Reconnect the connectors. Go to step 4. 4 Does the error still occur when the printer is turned On? Go to step 5. Complete. 5 1. Perform the Main Motor test: Service Mode > Printer Diag > Engine Diag > Motor Test > Main Motor. During the test, close the Front Cover. 2. Does the Motor operate properly? Replace the MCU Board. Go to step 6. 6 1. Check the Main Drive Assembly for correct installation. 2. Is the Main Drive Assembly securely installed? Go to step 7. Reseat the Main Drive Assembly. Go to step 7. 7 Does the error still occur when the printer is turned On? Go to step 8. Complete. 8 Check the Right Side Harness for continuity. 1. Disconnect P/J21 from the MCU Board. 2. Disconnect P/J211 from the Main Drive Assembly. 3. Check continuity between P/J21 <=> P/J211. Go to step 9. Replace the Right Side Harness. 9 Check the Main Drive signal. 1. Disconnect P/J21 on the MCU Board. 2. Is there +24 V across ground <=> J21-2/J21-4 pin when the Interlock Switch is activated? Replace the Main Drive Assembly. Replace the MCU Board.