Thương hiệu phân phối chính hãng
Giỏ hàng

Mã lỗi 042-700, 142-700 — Xerox Phaser 6180 MFP

Code: 042-700, 142-700

Description: Printer Too Hot The printer is too hot. The following troubleshooting procedure applies to this error. • Chain Link 042-700: Printer Too Hot (IOT Over Heat Stop) • Chain Link 142-700: Printer Too Hot (IOT Over Heat Forced Half Speed)
Causes: • Feeder Assembly, PL3.2.1 • MCU Board, PL9.2.13 • Humidity Harness, PL10.1.15
Remedy: 1 1. Check the room temperature. 2. Is the room temperature over 32° C? Adjust the room temperature to less than 32° C. Go to step 2. 2 Did the user print large print jobs? Go to step 6. Go to step 3. 3 1. Check the MCU Board for correct installation. Reseat the MCU Board. 2. Does the error still occur when printing? Go to step 4. Complete. 4 Check the Humidity Harness for continuity. 1. Disconnect P/J26 from the MCU Board. 2. Disconnect P/J261 from the Humidity/Temperature Sensor. 3. Check continuity between P/J26 <=> P/J261. Go to step 5. Replace the Humidity Harness. 5 1. Replace the MCU Board. 2. Does the error still occur when printing? Replace the Feeder Assembly. Complete. 6 Does the error still occur after the printer has cooled down for about five minutes? Go to step 3. Complete.

← Xem tất cả mã lỗi Xerox Phaser 6180 MFP

Đăng ký nhận bản tin Đăng ký nhận bản tin Đăng ký nhận bản tin Đăng ký nhận bản tin
Đăng ký nhận bản tin
Nhận ưu đãi sớm nhất khi chương trình diễn ra

Đăng ký nhận bản tin

Việc cho phép sử dụng cookie sẽ giúp cải thiện trải nghiệm của bạn trên trang web này. Chính sách cookie