Thương hiệu phân phối chính hãng
Giỏ hàng

Mã lỗi 092-651 — Xerox Phaser 6180 MFP

Code: 092-651

Description: ADC Sensor Error (Error Code 01) The ADC Sensor has detected density error. The following troubleshooting procedure applies to this error.
Causes: • Front Cover Harness, PL1.2.13 • Transfer Unit, PL4.1.1 • Print Cartridge (C/M/Y/K), PL5.1.17-20 • MCU Board, PL9.2.13 • Right Side Harness, PL10.1.12
Remedy: 1 1. Check the Transfer Unit for correct installation. 2. Is the Transfer Unit correctly installed? Go to step 3. Reseat the Transfer Unit. Go to step 2. 2 Does the error still occur when the printer is turned On? Go to step 3. Complete. 3 Check the toner density and compare the density of four colors toner. 1. Perform Gradation Test Print: Service Mode > Printer Diag > Test Print > Gradation ESS. 2. Is there dark color on the print? Go to step 4. Replace the MCU Board. 4 Check the Solenoid in the Transfer Unit for operation. 1. Perform the ADC Sensor Solenoid test: Service Mode > Printer Diag > Engine Diag > Motor Test > ADC (CTD) Sensor Solenoid. 2. Perform the ADC Sensor LED test: Service Mode > Printer Diag > Engine Diag > Motor Test > ADC (CTD) Sensor LED. 3. Does the ADC Sensor operate properly? Replace the corresponding Print Cartridge. Go to step 5. 5 1. Check the wiring harness connectors P/J27, P/J272, and P/ J2721 between the MCU Board and the Transfer Unit. 2. Are the connectors securely connected? Go to step 6. Reconnect the connectors. Go to step 10. 6 Check the Front Cover Harness for continuity. 1. Disconnect P/J2721 from the Transfer Unit. 2. Disconnect P/J272 from the Right Side Harness. 3. Check continuity between P/J2721 <=> P/J272. Go to step 7. Replace the Front Cover Harness. 7 Check the Right Side Harness for continuity. 1. Disconnect P/J27 from the MCU Board. 2. Disconnect P/J272 from the Front Cover Harness. 3. Check continuity between P/J27 <=> P/J272. Go to step 8. Replace the Right Side Harness. 8 Check the ADC Sensor signal. 1. Disconnect P/J27 from the MCU Board. 2. Is there +5 V across ground <=> J27-A7 pin on the MCU Board? Replace the Transfer Unit. Replace the MCU Board.

← Xem tất cả mã lỗi Xerox Phaser 6180 MFP

Đăng ký nhận bản tin Đăng ký nhận bản tin Đăng ký nhận bản tin Đăng ký nhận bản tin
Đăng ký nhận bản tin
Nhận ưu đãi sớm nhất khi chương trình diễn ra

Đăng ký nhận bản tin

Việc cho phép sử dụng cookie sẽ giúp cải thiện trải nghiệm của bạn trên trang web này. Chính sách cookie