Thương hiệu phân phối chính hãng
Giỏ hàng

Mã lỗi 07 ... 11 — Xerox Phaser 6300

Code: 07 ... 11

Description: Laser Failure An error was detected in the Laser Unit. Code 07: Laser power has failed Code 08: Start of Scan (SOS) failure 1 Code 09: Start of Scan (SOS) failure 2 Code 10: Warm up failure Code 11: This is the generic laser fault used by the engine if a lower level error cannot be reported to the controller.
Causes: • Laser Unit, PL6.1.2 • ROS Harness, PL6.1.3 • Engine Control Board, PL9.1.16
Remedy: 1 Check the Laser Unit connections. Are P/J15 and P/J151 connected? Go to Step 2. Connect the Laser Unit. 2 Remove and reseat ROS Harness connector J151 to the Laser Unit. Does the error persist? Go to Step 3. Complete 3 Replace the Laser Unit. Does the error persist? Go to Step 4. Complete 4 Check all pins on the ROS Harness PL6.1.3 for continuity. 1. Disconnect P/J15 and P/J151. 2. Check continuity between J15 <=> J151. Replace the Engine Control Board. Replace the ROS Harness.

← Xem tất cả mã lỗi Xerox Phaser 6300

Đăng ký nhận bản tin Đăng ký nhận bản tin Đăng ký nhận bản tin Đăng ký nhận bản tin
Đăng ký nhận bản tin
Nhận ưu đãi sớm nhất khi chương trình diễn ra

Đăng ký nhận bản tin

Việc cho phép sử dụng cookie sẽ giúp cải thiện trải nghiệm của bạn trên trang web này. Chính sách cookie