Thương hiệu phân phối chính hãng
Giỏ hàng

Mã lỗi 40 ... 43 — Xerox Phaser 6300

Code: 40 ... 43

Description: Fuser Failure The Fuser temperature regulation has failed. Code 40: The temperature sensor sensed an overheat condition. Code 41: The temperature sensor sensed a low temperature condition. Code 42: Temperature sensor not providing an output. Code 43: Warm up failure.
Causes: • Fuser, PL5.1.1 • FSR/ADC Harness, PL5.2.28 • LVPS, PL9.1.6 • Engine Control Board, PL9.1.16
Remedy: 1 Check the Fuser label for the correct rating. Is the Fuser properly rated (110v / 220v)? Go to Step 2. Replace the Fuser. 2 Check the Fuser for damage. Is the Fuser connector damaged? Replace the Fuser. Go to Step 3. 3 Replace the Fuser. Does the error persist? Go to Step 4. Complete 4 Replace the LVPS. Does the error persist? Go to Step 5. Complete 5 Check all pins on the FSR/ADC Harness PL5.2.28 for continuity. 1. Disconnect P/J36 and P/J361. 2. Check continuity between J36 <=> J361. Replace the Engine Control Board. Replace the FSR/ ADC Harness.

← Xem tất cả mã lỗi Xerox Phaser 6300

Đăng ký nhận bản tin Đăng ký nhận bản tin Đăng ký nhận bản tin Đăng ký nhận bản tin
Đăng ký nhận bản tin
Nhận ưu đãi sớm nhất khi chương trình diễn ra

Đăng ký nhận bản tin

Việc cho phép sử dụng cookie sẽ giúp cải thiện trải nghiệm của bạn trên trang web này. Chính sách cookie