Thương hiệu phân phối chính hãng
Giỏ hàng

Mã lỗi 45, 47 — Xerox Phaser 6350

Code: 45, 47

Description: Fuser Failure The Non Contact (NC) circuitry has failed. Code 45: NC Sensor circuit Failure Code 47: This is the generic Fuser code displayed when the printer cannot generate a specific error. This error code can represent any Fuser error code from 40 through 47. In this instance, all of the Fuser Failure troubleshooting procedures need to be completed until the error is resolved.
Causes: • Fuser, PL5.1.1 • FSR/ADC Harness, PL5.2.28 • Engine Control Board, PL9.1.16
Remedy: 1 Check the Fuser label for the correct rating. Is the Fuser properly rated (110v/220v)? Go to Step 2. Replace the Fuser. 2 Check the Fuser for damage. Is the Fuser connector damaged? Repair or replace the Fuser. Go to Step 3. 3 Replace the Fuser. Does the error persist? Go to Step 4. Complete 4 Check all pins on the FSR/ADC Harness PL5.2.28 for continuity. 1. Disconnect P/J36 and P/J361. 2. Check continuity between J36 <=> J361. Replace the Engine Control Board. Replace the FSR/ ADC Harness.

← Xem tất cả mã lỗi Xerox Phaser 6350

Đăng ký nhận bản tin Đăng ký nhận bản tin Đăng ký nhận bản tin Đăng ký nhận bản tin
Đăng ký nhận bản tin
Nhận ưu đãi sớm nhất khi chương trình diễn ra

Đăng ký nhận bản tin

Việc cho phép sử dụng cookie sẽ giúp cải thiện trải nghiệm của bạn trên trang web này. Chính sách cookie