Thương hiệu phân phối chính hãng
Giỏ hàng

Mã lỗi 90 ... 99 — Xerox Phaser 6350

Code: 90 ... 99

Description: Code 90: Cyan CRUM ID Error Code 91: Magenta CRUM ID Error Code 92: Yellow CRUM ID Error Code 93: Black CRUM ID Error Code 96: Non-Xerox Cyan Toner Cartridge Detected Code 97: Non-Xerox Magenta Toner Cartridge Detected Code 98: Non-Xerox Yellow Toner Cartridge Detected Code 99: Non-Xerox Black Toner Cartridge Detected. Replace [Y] [M] [C] [K] Toner Cartridge The CRUM Reader detected a CRUM ID error or a Non-Xerox Toner Cartridge. An empty or non-genuine Xerox cartridge, a fatal cartridge error, or a fatal printer error can cause this error. Check for an error code in the help text prior to troubleshooting. If a code in the range of 232~235 appears, or no code is present, see "Replace [Y] [M] [C] [K] Toner Cartridge or [Y] [M] [C] [K] Toner Is Low". A Non-Xerox Toner Cartridge warning message occurs when the printer detects the presence of Non-Xerox Toner. The customer can continue to print by selecting use it on the Control Panel when queried whether to use the Non-Xerox cartridge. If the customer chooses Do Not Use, the warning message is replaced by the Replace [C] [M] [Y] [K] Toner Cartridge error message and the associate codes (96 ~ 99) appear in the help text.
Causes: • Toner Cartridge, PL7.2.8 • RFID Harness, PL7.2.17 • RFID2 Harness, PL7.2.16 • CRUM Reader, PL7.2.12
Remedy: 1 Check Toner Cartridge installation. Are the Toner Cartridges properly installed? Go to Step 2. Correct the installation. 2 Replace the affected Toner Cartridge. Does the error persist after a genuine Xerox Toner Cartridge is installed? Go to Step 3. Complete 3 Check the CRUM Reader Board connection. Is P/J341 connected to the harness? Go to Step 4. Reconnect the CRUM Reader Board 4 Replace the CRUM Reader Board. Does the error persist? Go to Step 5. Complete 5 Check all pins on the RFID2 Harness PL7.2.16 for continuity. 1. Disconnect P/J341 and P/J3411. 2. Check continuity between J341<=>J3411. Go to Step 6. Replace the RFID2 Harness. 6 Check all pins on the RFID Harness PL7.2.17 for continuity. 1. Disconnect P/J3411 and P/J34. 2. Check continuity between P3411<=>J34. Replace the Engine Control Board. Replace the RFID Harness.

← Xem tất cả mã lỗi Xerox Phaser 6350

Đăng ký nhận bản tin Đăng ký nhận bản tin Đăng ký nhận bản tin Đăng ký nhận bản tin
Đăng ký nhận bản tin
Nhận ưu đãi sớm nhất khi chương trình diễn ra

Đăng ký nhận bản tin

Việc cho phép sử dụng cookie sẽ giúp cải thiện trải nghiệm của bạn trên trang web này. Chính sách cookie