Thương hiệu phân phối chính hãng
Giỏ hàng

Mã lỗi 13 ... 16 — Xerox Phaser 6360

Code: 13 ... 16

Description: Density Sensor Failure An error was detected in the CTD (ADC) sensor. Code 13: Density Sensor Failure. Code 14: Density Limit Over Output. Code 15: Density Limit. Code 16: This is the generic fault used by the engine if a lower level error cannot be reported to the controller.
Causes: • Transfer Roller, PL5.1.4 • FSR/ADC Harness, PL5.2.28 • CTD(ADC) Sensor Holder, PL5.2.19
Remedy: 1 Check the following for evidence of fault or damage: • Transfer Roller, PL5.1.4 • CTD (ADC) Sensor Holder, PL5.2.19 Are any parts damaged? Replace any damaged parts. Go to Step 2. 2 Clean the CTD (ADC) Sensor. Does the error persist? Go to Step 3. Complete 3 Test the CTD (ADC) Sensor. Run the Service Diagnostics CTD (ADC) Sensor test. Does the sensor function correctly? Go to Step 4. Go to Step 5. 4 Replace the Transfer Roller. Does the error persist? Go to Step 5. Complete 5 Check all pins on the FSR/ADC Harness PL5.2.28 for continuity. 1. Disconnect P/J36 and P/J136. 2. Check continuity between J36 <=> J136. Go to Step 6. Replace the FSR/ ADC Harness. 6 Check the CTD (ADC) Sensor signal. Disconnect P/J136. Is there 0 V across P136-4 <=> P136-1? Replace the CTD (ADC) Sensor Holder. Replace the Engine Control Board.

← Xem tất cả mã lỗi Xerox Phaser 6360

Đăng ký nhận bản tin Đăng ký nhận bản tin Đăng ký nhận bản tin Đăng ký nhận bản tin
Đăng ký nhận bản tin
Nhận ưu đãi sớm nhất khi chương trình diễn ra

Đăng ký nhận bản tin

Việc cho phép sử dụng cookie sẽ giúp cải thiện trải nghiệm của bạn trên trang web này. Chính sách cookie