Thương hiệu phân phối chính hãng
Giỏ hàng

Mã lỗi 166 ... 169 — Xerox Phaser 6360

Code: 166 ... 169

Description: Out of Paper; Load Tray [2][3][4][5] with [size][type] The No Paper Sensor for the indicated tray reports the tray is empty. Code 166: Out of Paper; Load Tray 2 Code 167: Out of Paper; Load Tray 3 Code 168: Out of Paper; Load Tray 4 Code 169: Out of Paper; Load Tray 5
Causes: For Tray 2: • No Paper Sensor, PL3.3.7 • No Paper Actuator, PL3.3.20 • FDR Harness, 3.3.22 For 550-Sheet Feeder: • No Paper Sensor, PL11.3.7 • No Paper Actuator, PL11.3.22 • OPFDR Harness, 11.3.24 For 1100-Sheet Feeder: • No Paper Sensor, PL12.4.7 • No Paper Actuator, PL12.3.22 • OPFDR2 Harness, 12.3.7
Remedy: 1 Fill the tray. Does the error occur even if the tray is full? Go to Step 2. Complete 2 Check the following for evidence of fault or damage: • No Paper Sensor, PL3.3.7, PL11.3.7, PL12.4.7 • No Paper Actuator, PL3.3.20, PL11.3.22, PL12.3.22 Is there any damage? Replace any damaged parts. Go to Step 3. 3 Test the No Paper Sensor. for the affected tray. Run the Service Diagnostics No Paper Sensor test. Does the sensor function correctly? Replace the Engine Control Board. Go to Step 4. 4 Check the No Paper Sensor signal. For Tray 2: Is there +3.3 V across P/J472-1 <=> P/J472? For Tray 3, 4, and 5: Is there +3.3 V across P/J822-1 <=> P/J822-2? Go to Step 5. Replace the No Paper Sensor. 5 Check all pins on the FDR Harness for continuity. For Tray 2: 1. Disconnect P/J47 and P/J472. 2. Check continuity between J47 <=> J472. For Tray 3, 4, 5: 1. Disconnect P/J85 and P/J822. 2. Check continuity between J85 <=> J822. Replace the Engine Control Board. Replace the FDR Harness.

← Xem tất cả mã lỗi Xerox Phaser 6360

Đăng ký nhận bản tin Đăng ký nhận bản tin Đăng ký nhận bản tin Đăng ký nhận bản tin
Đăng ký nhận bản tin
Nhận ưu đãi sớm nhất khi chương trình diễn ra

Đăng ký nhận bản tin

Việc cho phép sử dụng cookie sẽ giúp cải thiện trải nghiệm của bạn trên trang web này. Chính sách cookie