Remedy: 1 Check the connections between the MCU Board and Humidity Sensor. Are P/J20 and P/J201 connected surely? Go to step 3. Reconnect the connector(s) P/ J20 and/or P/ J201 surely, then go to step 2 2 Does the error still occur when the power is turned Off and On? Go to step 3. Complete. 3 Disconnect P/J20 from the MCU Board. Disconnect P/J201 from the Humidity Sensor. Is each wire of P/J20 <=> P/J201 continuous? Go to step 4. SFP: Replace the Humidity Harness Assy. (PL 9.1.6) MFP: Replace the Left Side Harness Assy. (PL 3.1 18) 4 Disconnect P/J20 on the MCU Board. Is the voltage across ground <=> J20-4 on the MCU Board, about +5VDC? Replace the Humidity Sensor. Replace the MCU Board.