Code: 075-101, 075-102, 075-923
Description: IOT SSF Insert JAM / IOT SSF Paper Pullout JAM / Waiting for reseat paper of SSF
Causes: • Left Side Harness Assy (PL3.1.18) • Manual Feed No Paper Sensor (Sensor Photo) (PL3.2.13) • MCU Board (SFP PL8.2.13; MFP PL8.3.6)
Remedy: 1 Check the customer operation. Did the customer insert the paper to the Manual Feed slot during print? After print completion, insert the paper to the Manual Feed slot. Go to step 2. 2 Perform the procedure “Manual Feed Sensor” on page 4-20 to check operation of the Manual Feed No Paper Sensor. Does the number on the screen increase by one when you insert paper? Go to step 3. Go to step 4. 3 Check the error. Does the error still occur when printing? Replace the MCU Board. Complete. 4 Check the connections between the MCU Board and Manual Feed No Paper Sensor. Are P/J23 and P/J233 connected correctly? Go to step 6. Reconnect the connector(s) P/ J23 and/or P/ J233 correctly, then go to step 5. 5 Does the error still occur when printing? Go to step 6. Complete. 6 Check the Left Side Harness Assy for continuity. Disconnect J23 from the MCU Board. Disconnect J233 from the Manual Feed No Paper Sensor. Is each cable of J23 <=> J233 continuous? Go to step 7. Replace the Left Side Harness Assy. (PL 3.1.18) 7 Check the power to the Manual Feed No Paper Sensor. Disconnect J23 from the MCU Board. Is the voltage across P23-6 <=> ground on the MCU Board about +3.3 VDC? Go to step 8. Replace the MCU Board. 8 Check the voltage across J23-8 <=> ground on the MCU Board. Remove the Lower Chute Assembly to check the operation of the Manual Feed No Paper Sensor. Does the voltage change when you operate the Manual Feed Actuator? Replace the MCU Board. Replace the Manual Feed No Paper Sensor.