Code: 077-104, 077-105
Description: IOT Exit Off JAM / IOT Exit Off early JAM
Causes: • Fuser Assy (PL6.1.1) • MCU Board (SFP PL8.2.13; MFP PL8.3.6) • Fuser Harness Assy (PL6.1.2) • Feeder Assy. (PL 3.1.98) • Drive Clutch Assy. (PL 3.1.97)
Remedy: 1 Check the error. Replace to known good paper. Does the error still occur when printing? Go to step 2. Complete. 2 Perform the procedure “Exit Sensor” on page 4-23 to check the Exit Sensor operation. Does the number on the screen increase by one, when you operate the Exit Sensor actuator in the Fuser Assy? Go to step 7. Go to step 3. 3 Check the connectors of the Exit Sensor in the Fuser Assy for connection. Check the connections between the MCU Board and Fuser Assy. Are P/J17 and P/J171 connected correctly? Go to step 4. Reconnect the connector(s) P/ J17 and/or P/ J171 correctly. 4 Check the Fuser Harness Assy for continuity. Remove the Fuser Assy. Disconnect J17 from the MCU Board. Is each cable of J17 <=> P171 continuous? NOTE: P171 is attached to the frame. Go to step 5. Replace the Fuser Harness Assy. 5 Check the power to the Exit Sensor in the Fuser Assy. Disconnect the connector of J17 on the MCU Board. Is the voltage across J17-1 <=> ground on the MCU Board, about +3.3 VDC? Go to step 6. Replace the MCU Board. 6 Check the Exit Sensor for operation. Check the voltage across J17-3 <=> ground on the MCU Board. Does the voltage change, when the actuator of the Exit Sensor is operated? Replace the MCU Board. Replace the Fuser Assy. After replacing the Fuser, be sure to reset the Fuser counter. 7 Open the Front Cover and check the Registration Rollers. Is the metal roller pressed against the rubber roller by the spring pressure? Go to step 8. Replace Feeder Assy. 8 Perform the first part of the procedure “Registration Clutch” on page 4-33 to check the Registration Clutch. Do you hear a click when the clutch is energized? Replace the MCU Board. Replace the Drive Clutch Assy.