Causes: • Left Side Harness Assy (PL3.1.18) • Manual Feed No Paper Sensor (Sensor Photo) (PL3.2.13) • MCU Board (SFP PL8.2.13; MFP PL8.3.6)
Remedy: 1 Perform the procedure “Manual Feed Sensor” on page 4-20 to check operation of the Manual Feed No Paper Sensor. Does the number on the screen increase by one when you insert paper? Replace the MCU Board. Go to step 2. 2 Check the connections between the MCU Board and Manual Feed No Paper Sensor. Are P/J23 and P/J233 connected correctly? Go to step 3. Reconnect the connector(s) P/ J23 and/or P/ J233 correctly. 3 Check the Left Side Harness Assy for continuity. Disconnect J23 from the MCU Board. Disconnect J233 from the Manual Feed No Paper Sensor. Is each cable of J23 <=> J233 continuous? Go to step 4. Replace the Left Side Harness Assy. (PL 3.1.18) 4 Check the power to the Manual Feed No Paper Sensor. Disconnect J23 from the MCU Board. Is the voltage across P23-6 <=> ground on the MCU Board, about +3.3 VDC? Replace the Manual Feed No Paper Sensor. Replace the MCU Board.