Remedy: 1 Does the error still occur when the power is turned Off and On? Go to step 2. Complete. 2 Check after resetting the Humidity Sensor. Reseat the Humidity Sensor. Does the error still occur when the power is turned Off and On? Go to step 3. Complete. 3 Check the Left Side Harness Assy for continuity. Disconnect J20 from the MCU Board. Disconnect J201 from the Humidity Sensor. Is each cable of J20 <=> J201 continuous? Go to step 4. SFP: Replace the Humidity Harness Assy. (PL 9.1.6) MFP: Replace the Left Side Harness Assy. (PL 3.1.18) 4 Check power to Humidity Sensor. Disconnect the connector of J20 from the MCU Board. Measure the voltage across P20-4 <=> ground on the MCU Board. Does the voltage measure about +5 VDC? Replace the Humidity Sensor. Replace the MCU Board.