Code: 093-926, 093-960, 093-961, 093-962
Description: IOT (YMCK) CRUM ID Error
Causes: • CRUM Connector (PL5.1.14) • Toner Cartridge (Y) (PL5.1.24) • Toner Cartridge (M) (PL5.1.23) • Toner Cartridge (C) (PL5.1.22) • Toner Cartridge (K) (PL5.1.21) • Toner CRUM Harness Assy (PL5.1.26) • MCU Board (SFP PL8.2.13; MFP PL8.3.6)
Remedy: 1 Close the Toner Door correctly. Does the error still occur when the power is turned Off and On? Go to step 2. Complete. 2 Check the toner type. Is XEROX Toner installed? Go to step 3. Verify that the non-Xerox toner in use is compatible with the Phaser 6500/ WorkCentre 6505 printers. 3 Reseat the Toner Cartridge (Y, M, C or K), and check that the lock key is in the lock position. Does the error still occur when the power is turned Off and On? Go to step 4. Complete. 4 Replace the Toner Cartridge (Y, M, C or K), and check that the lock key is in the lock position. Does the error still occur when the power is turned Off and On? Go to step 5. Complete. 5 Check the connectors between the MCU Board and CRUM Connector. Are P/J31 and P/J311(Y), P/J312(M), P/ J313(C), P/J314(K) connected correctly? Go to step 7. Reconnect P/ J31 and/or P/J311 (Y), P/J312 (M), P/J313 (C), P/J314 (K) securely, then go to step 6. 6 Does the error still occur when the power is turned Off and On? Go to step 7. Complete. 7 Check the Toner CRUM Harness Assy for continuity. Disconnect J31 from the MCU Board. Disconnect J311, J312, J313, and/or J314 from the CRUM Connector. Is each cable of J31 <=> J311/J312/ J313/J314 continuous? Go to step 8. Replace the Toner CRUM Harness Assy (Y, M, C or K). 8 Check the output power of CRUM Connector (Y, M, C or K). Disconnect P/J31 on the MCU Board. Is the voltage across ground <=> P31-3(Y), -7(M), -11(C), -15(K) on the MCU Board, about +3.3VDC? Replace the CRUM Connector (Y, M, C or K). Replace the MCU Board.