Remedy: 1 Does the error still occur when the power is turned Off and On? Go to step 2. Complete. 2 Check the Toner Type. Is XEROX Toner installed? Go to step 3. Verify that the non-Xerox toner in use is compatible with the Phaser 6500/ WorkCentre 6505 printers. 3 Reseat the Toner Cartridge (Y, M, C or K), and check that the lock key is in the lock position. Does the error still occur when the power is turned Off and On? Go to step 4. Complete. 4 Replace the Toner Cartridge (Y, M, C or K). Does the error still occur when the power is turned Off and On? Go to step 5. Complete. 5 Check the Toner CRUM Harness Assy for continuity. Disconnect J31 from the MCU Board. Disconnect J311 (Y) from the CRUM Connector. Are P/J31 and P/J311(Y),P/J312(M),P/ J313(C),P/J314(K) connected correctly? Go to step 6. Replace the Toner CRUM Harness Assy 6 Reseat the MCU Board connectors. Does the error still occur when the power is turned Off and On? Replace the MCU Board. Complete.