Description: Jam at Finisher - Compile Exit Sensor Jam Compile Exit Sensor state change not detected within the specified time. This typically indicates media stuck in the Compile Tray or Horizontal Transport. • 12-450-00 Jam at Finisher
Remedy: 1 Test the Compile Exit Sensor using dc330 (012-029). To actuate the sensor, open the Horizontal Transport Cover and use the Exit Roller Knob to manually feed media into the Compile Tray. The sensor signal changes (On/Off). Go to Step 7. Go to Step 2. 2 Check for 5V at P/J8869-1. Is 5 V available at P/J8869-1? Replace the Compile Exit Sensor. Go to Step 3 3 Check Finisher Main Board connection P/J8989. The connection is secure and undamaged. Go to Step 4. Secure the connection. 4 Check for 5V at P/J8989-12B on the Finisher Main Board. Is 5 V available at P/J8989-12B? Replace the SNR2 harness. Go to Step 5. 5 Check for 24V at P/J8884-4 on the Finisher Main Board. Is 24V available at P/J8884-4? Replace the Finisher Main Board. Go to Step 6. 6 Remove the Finisher LVPS harness and check continuity between P/ J591 on the LVPS and P/J8980 on the Finisher Main Board. The harness is undamaged. Replace the Finisher LVPS. Replace the harness. 7 Check Finisher connections P/J8890 and CN4 to the printer. The connections are secure and undamaged. Go to Step 8. Secure the connections. 8 Remove the Finisher I/F harness and check continuity between P/J8890 and CN4. The harness is undamaged. Go to Step 9. Replace the harness. 9 Check P/J22 on the MCU Board. The connection is secure and undamaged. Go to Step 10. Secure the connection. 10 Remove the Finisher harness and check continuity between P/J22 and P/J122. The harness is undamaged. Go to Step 11. Replace the harness. 11 Replace the Finisher Main Board. Does the error persist? Replace the MCU Board. Complete.