Description: Jam at Finisher - Compile No Paper Sensor Jam Compile No Paper Sensor state change not detected within the specified time. This typically indicates media stuck in the Compile Tray possibly due to an eject failure. • 12-450-00 Jam at Finisher • 312.452.01 Compile No Paper Sensor On failure • 312.454.01 Media remains at Compile Tray No Paper Sensor
Causes: • MCU Board, PL10.2.18 • Compile No Paper Sensor, PL14.8.13 • Finisher Main Board, PL14.4.12 • SN1 Harness, PL14.11.5
Remedy: 1 Test the Compile No Paper Sensor using dc330 (012-030). To actuate the sensor, lift the Compile Tray’s Eject Pinch Roller Assy and using a pencil or similar tool, push down on the actuator. The sensor signal changes (On/Off). Go to Step 5. Go to Step 2. 2 Check for 5V at P/J8988-3 on the Finisher Main Board. Is 5 V available at P/J8988-3? Replace the Compile No Paper Sensor. Go to Step 3 3 Check for 24V at P/J8884-4 on the Finisher Main Board. Is 24V available at P/J8884-4? Replace the Finisher Main Board. Go to Step 4. 4 Remove the Finisher LVPS harness and check continuity between P/ J591 on the LVPS and P/J8980 on the Finisher Main Board. The harness is undamaged. Replace the Finisher LVPS. Replace the harness. 5 Check Finisher connections P/J8890 and CN4 to the printer. The connections are secure and undamaged. Go to Step 6. Secure the connections. 6 Remove the Finisher I/F harness and check continuity between P/J8890 and CN4. The harness is undamaged. Go to Step 7. Replace the harness. 7 Check P/J22 on the MCU Board. The connection is secure and undamaged. Go to Step 8. Secure the connection. 8 Remove the Finisher harness and check continuity between P/J22 and P/J122. The harness is undamaged. Go to Step 9. Replace the harness. 9 Replace the Finisher Main Board. Does the error persist? Replace the MCU Board. Complete.