Description: Finisher Output Tray is Jammed The Stack Height Sensors indicate the Stacker Drive Assembly did not move the Stacker Tray to the home position.
Remedy: 1 Test Stack Height Sensor 1 using dc330 (012-040). The signal changes (On/Off). Go to Step 4. Go to Step 2. 2 Checking SNR2 Harness continuity between P/J8989 on the Finisher Main Board and P/J8873 from the sensor. The harness is undamaged? Go to Step 3. Replace the harness. 3 Checking for 5V at P/J8989-6B on the Finisher Main Board. Is 5V available at J8989-6B on the Finisher Main Board? Replace Stack Height Sensor 1. Go to Step 10. 4 Test Stack Height Sensor 2 using dc330 (012-041). The signal changes (On/Off). Go to Step 7. Go to Step 5. 5 Checking SNR2 Harness continuity between P/J8989 on the Finisher Main Board and P/J8874 from the sensor. The harness is undamaged? Go to Step 6. Replace the harness. 6 Checking for 5V at P/J8989-9B on the Finisher Main Board. Is 5V available at J8989-9B on the Finisher Main Board? Replace Stack Height Sensor 2. Go to Step 10. 7 Test the Stacker Drive Assy using dc330 (012-060 up/ 012-061 down). The Stacker Tray moves. Go to Step 10. Go to Step 8. 8 Checking MOT3 Harness continuity between P/J8983 on the Finisher Main Board and P/J8891 from the Stacker Drive Assy. The harness is undamaged? Go to Step 9. Replace the harness. 9 Checking for 24V at P/J8986-1 and - 2 on the Finisher Main Board. Is 24V available at J8986-1and -3? Replace the Stacker Drive Assy. Go to Step 10. 10 Replace the Finisher Main Board. The error persists. Replace the MCU Board. Complete.