Code: 310.311.02 ... 310.338.19
Description: Fuser Failure A failure was detected in the Fuser. • 310.311.02 STS Disconnect error • 310.312.05 Detection sensor disconnect • 310.313.06 AD output detection error • 310.314.07 Compensation sensor disconnect • 310.315.09 AD output detection error (at NC) • 310.316.12 STS-NC damage • 310.317.13 NC low temp error • 310.318.14 STS low temp error • 310.319.04 Differential amp circuit damage • 310.320.03 STS high temp error • 310.321.15 Hard relay off • 310.322.16 Main data update error • 310.323.17 Sub data update error • 310.324.20 Continuous lamp on error (sub) • 310.325.22 Unexpected status • 310.326.21 Cool down timeout • 310.327.23 Unexpected status • 310.328.18 Warm up ready timeout • 310.333.10 NC high temp error • 310.334.11 STS-NC damage • 310.335.08 AD output detection error • 310.338.19 Continuous lamp on error (main)
Causes: • Fuser, PL7.1.99 • Harness Assy FSR, PL7.1.4 • MCU Board, PL10.2.18 • LVPS Cage, PL10.2.1
Remedy: • Reseat the Fuser in the printer. • Cycle system power. • If the problem persists, follow the procedure below.
1 Replace the Fuser. Does the error persist? Go to Step 2. Complete. 2 Check Fuser connections PJ180-S and P/J1 on the MCU Board. The connections are secure and undamaged. Go to Step 3. Replace the harness. 3 Remove the Fuser harness and check continuity between P/J1 and P/ J180-S. The harness is undamaged. Replace the MCU Board. Replace the harness. 4 Check Fuser connector P/J180 and LVPS connector P/J304. The connections are secure and undamaged. Go to Step 5. Secure the connections. 5 Check Fuser harness continuity between P/J180 to LVPS P/J304. The harness is undamaged. Go to Step 6. Replace the harness 6 Replace the MCU Board. Does the error persist? Replace the LVPS. Complete.
1 Replace the Fuser. Does the error persist? Go to Step 2. Complete. 2 Check Fuser connections PJ180-S and P/J1 on the MCU Board. The connections are secure and undamaged. Go to Step 3. Replace the harness. 3 Remove the Fuser harness and check continuity between P/J1 and P/ J180-S. The harness is undamaged. Replace the MCU Board. Replace the harness. 4 Check Fuser connector P/J180 and LVPS connector P/J304. The connections are secure and undamaged. Go to Step 5. Secure the connections. 5 Check Fuser harness continuity between P/J180 to LVPS P/J304. The harness is undamaged. Go to Step 6. Replace the harness 6 Replace the MCU Board. Does the error persist? Replace the LVPS. Complete.