Description: Finisher Failure - Stapler Home Position Staple Head Home Sensor On not detected within the specified time after staple motor reverse rotation starts.
Remedy: 1 Check stapler motion by rotating the black gears on the side of the Stapler. The mechanism moves freely. Go to Step 2. Replace the Stapler. 2 Test Stapler Home Position Sensor using dc330 (012-035) and rotating Stapler gears to move the Stapler clamp in and out of the sensing area. The sensor signal changes (On/Off). Go to Step 6. Go to Step 3. 3 Check Stapler connections to the Finisher Main Board P/J8886 and P/ J8988. The connections are secure and undamaged. Go to Step 4. Secure the connections. 4 Check SNR1 harness continuity between P/J8988 and P/J8886. The harness is undamaged. Go to Step 5. Replace the harness. 5 With Stapler Home Position Sensor turned On in diagnostics, check for 5V at P/J8886-5. Is 5 V available at P/J8886-5? Replace the Stapler. Replace the Finisher Main Board. 6 Check for 24V at P/J8980-1 of the LVPS harness. Is 24V available at P/J8884-1? Replace the MCU Board. Go to Step 7. 7 Remove the Finisher LVPS harness and check continuity between P/ J591 on the LVPS and P/J8980 on the Finisher Main Board. The harness is undamaged. Replace the Finisher LVPS. Replace the harness. 8 Replace the Finisher Main Board. Does the error persist? Replace the MCU Board. Complete.