Thương hiệu phân phối chính hãng
Giỏ hàng

Mã lỗi 312.450.01, 312-451-00, 312.451.01, 312.453.01 — Xerox Phaser 6700

Code: 312.450.01, 312-451-00, 312.451.01, 312.453.01

Description: Jam at Finisher - Compile Exit Sensor Jam Compile Exit Sensor state change not detected within the specified time. This typically indicates media stuck in the Compile Tray or Horizontal Transport. • 312.450.01 Compile Exit Sensor On failure • 312-451-00 Jam in Horizontal Transport • 312.451.01 Compile Exit Sensor Off failure • 312.453.01 Media remains at Compile Exit Sensor
Causes: • MCU Board, PL10.2.18 • Compile Exit Sensor, PL14.7.9 • Finisher Main Board, PL14.4.12 • SN2 Harness, PL14.11.6
Remedy: 1 Test the Compile Exit Sensor using dc330 (012-029). To actuate the sensor, open the Horizontal Transport Cover and use the Exit Roller Knob to manually feed media into the Compile Tray. The sensor signal changes (On/Off). Go to Step 7. Go to Step 2. 2 Check for 5V at P/J8869-1. Is 5 V available at P/J8869-1? Replace the Compile Exit Sensor. Go to Step 3 3 Check Finisher Main Board connection P/J8989. The connection is secure and undamaged. Go to Step 4. Secure the connection. 4 Check for 5V at P/J8989-12B on the Finisher Main Board. Is 5 V available at P/J8989-12B? Replace the SNR2 harness. Go to Step 5. 5 Check for 24V at P/J8884-4 on the Finisher Main Board. Is 24V available at P/J8884-4? Replace the Finisher Main Board. Go to Step 6. 6 Remove the Finisher LVPS harness and check continuity between P/ J591 on the LVPS and P/J8980 on the Finisher Main Board. The harness is undamaged. Replace the Finisher LVPS. Replace the harness. 7 Check Finisher connections P/J8890 and CN4 to the printer. The connections are secure and undamaged. Go to Step 8. Secure the connections. 8 Remove the Finisher I/F harness and check continuity between P/J8890 and CN4. The harness is undamaged. Go to Step 9. Replace the harness. 9 Check P/J22 on the MCU Board. The connection is secure and undamaged. Go to Step 10. Secure the connection. 10 Remove the Finisher harness and check continuity between P/J22 and P/J122. The harness is undamaged. Go to Step 11. Replace the harness. 11 Replace the Finisher Main Board. Does the error persist? Replace the MCU Board. Complete.

← Xem tất cả mã lỗi Xerox Phaser 6700

Đăng ký nhận bản tin Đăng ký nhận bản tin Đăng ký nhận bản tin Đăng ký nhận bản tin
Đăng ký nhận bản tin
Nhận ưu đãi sớm nhất khi chương trình diễn ra

Đăng ký nhận bản tin

Việc cho phép sử dụng cookie sẽ giúp cải thiện trải nghiệm của bạn trên trang web này. Chính sách cookie