Description: Misfeed in Tray 3 ~ 6 Media fed from the indicated Tray did not reach the Take Away Sensor on time. • 373.101.01 Tray 3 misfeed • 374.101.02 Tray 4 misfeed • 375.101.03 Tray 5 misfeed • 376.101.04 Tray 6 misfeed
Remedy: 1 Check the Feed, Nudger, Separator, and Take Away Rollers for wear, contamination or damage. The rollers are clean and undamaged. Go to Step 2. Replace the affected rollers. 2 Test the Take Away Sensor for the affected tray using dc330: • Tray 3 (73-001) • Tray 4 (74-007) • Tray 5 (75-007) • Tray 6 (76-010) The sensor signal changes (On/Off). Go to Step 4. Go to Step 3. 3 Check for 3.3V at P/J353-5 on the Feeder Board. Is 3.3 V available at P/J353-5 when the Interlock Switch is closed? Replace the Take Away Sensor. Go to Step 9. 4 Test the Feed Drive Motor Alarm for the affected tray using dc330 • Tray 3 (73-012) • Tray 4 (74-006) • Tray 5 (75-004) • Tray 6 (76-009) The alarm signal changes (On/Off). Replace the affected Feed Drive Assy. Go to Step 5. 5 Test the Take Away Clutch for the affected tray using dc771: • Tray 3 (73-013) • Tray 4 (74-004) • Tray 5 (75-005) • Tray 6 (76-005) The clutch signal changes (On/Off). Go to Step 7. Go to Step 6. 6 Check for 24V at P/J354-1 on the Feeder Board. Is 24 V available at P/J355-1 when the Interlock Switch is closed? Replace the Take Away Clutch. Go to Step 9. 7 Test the Feed Clutch for the affected tray using dc330: • Tray 3 (73-014) • Tray 4 (74-005) • Tray 5 (75-005) • Tray 6 (76-005) The clutch signal changes (On/Off). Go to Step 8 Go to Step 9. 8 Check for 24V at P/J354-3 on the Feeder Board. Is 24 V available at P/J354-3 when the Interlock Switch is closed? Replace the Feed Clutch. Go to Step 9. 9 Replace the affected Tray’s Feeder Board. The error persists. Go to Step 10. Complete. 10 Replace the MCU Board. The error persists. Visually inspect and test continuity of all applicable harnesses. Complete.