Description: Misfeed in Tray 1 Media fed from Tray 1 did not reach the Registration Sensor on time. • 71-101-00 Tray 1 misfeed • 371.101.08 Tray 1 misfeed
Remedy: 1 Check the Feed and Separator Rollers for contamination or damage. The rollers are clean and undamaged. Go to Step 2. Clean or replace the rollers. 2 Test the Registration Sensor using dc330 (10-202). The signal changes (On/Off). Go to Step 4. Go to Step 3. 3 Check for 3.3V at P/J10-7 on the MCU Board. Is 3.3 V available at P/J10-7 when the Front Interlock Switch is closed? Replace the Registration Sensor. Replace the MCU Board. 4 Test the Paper Feed motor Alarm using dc330 (10-204). The signal changes (On/Off). Replace the Feed Drive Assy. Go to Step 5. 5 Test the Tray 1 Feed Solenoid using dc330 (71-006). The solenoid plunger moves. Go to Step 7. Go to Step 6. 6 Check for 24V at P/J9-10 on the MCU Board. Is 24 V available at P/J9-10? Replace the Solenoid, Gear & Clutch Kit. Replace the MCU Board. 7 Test the Take Away Clutch using dc330 (72-008) The clutch signal changes (On/Off). Go to Step 9. Go to Step 8. 8 Check for 24V at P/J10-5 on the MCU Board Is 24 V available at P/J10-5?. Replace the Take Away Clutch. Go to Step 9. 9 Replace the MCU Board. The error persists. Visually inspect and test continuity of all applicable harnesses. Complete.