Thương hiệu phân phối chính hãng
Giỏ hàng

Mã lỗi 72-101-00, 372.101.09 — Xerox Phaser 6700

Code: 72-101-00, 372.101.09

Description: Misfeed in Tray 2 Media fed from Tray 2 did not reach the Registration Sensor on time.
Causes: • Feed & Separator Roller Kit PL2.1.99 • Feed Clutch, PL3.2.2 • Take Away Clutch, PL3.3.12 • Registration Sensor, PL3.3.22 • Registration Sensor Harness, PL3.3.23 • Feed Drive, PL9.1.4 • MCU Board, PL10.2.18 • Registration Harness, PL11.1.5 • Harness RH/ MOT, PL11.2.3
Remedy: 1 Check the Feed and Separator Rollers for contamination, wear or damage. The rollers are clean and undamaged. Go to Step 2. Replace the rollers. 2 Test the Registration Sensor using dc330 (10-202). The signal changes (On/Off). Go to Step 4. Go to Step 3. 3 Check for 3.3V at P/J10-7 on the MCU Board. Is 3.3 V available at P/J10-7 when the Front Interlock Switch is closed? Replace the Registration Sensor. Replace the MCU Board. 4 Test the Feed Drive Motor Alarm using dc330 (10-204). The signal changes (On/Off). Replace the Feed Drive Assy. Go to Step 5. 5 Test the Take Away Clutch using dc330 (72-008) The clutch signal changes (On/Off). Go to Step 7. Go to Step 6. 6 Check for 24V at P/J10-5 and -10 on the MCU Board. Is 24 V available at P/J10-5? Replace the Take Away Clutch. Replace the MCU Board. 7 Test the Feed Clutch using dc330 (72-007) The clutch signal changes (On/Off). Go to Step 8. Go to Step 9. 8 Check for 24V at P/J10-3 on the MCU Board. Is 24 V available at P/J10-3? Replace the Feed Clutch. Go to Step 9. 9 Replace the MCU Board. The error persists. Visually inspect and test continuity of all applicable harnesses. Complete.

← Xem tất cả mã lỗi Xerox Phaser 6700

Đăng ký nhận bản tin Đăng ký nhận bản tin Đăng ký nhận bản tin Đăng ký nhận bản tin
Đăng ký nhận bản tin
Nhận ưu đãi sớm nhất khi chương trình diễn ra

Đăng ký nhận bản tin

Việc cho phép sử dụng cookie sẽ giúp cải thiện trải nghiệm của bạn trên trang web này. Chính sách cookie