Description: Engine Sensor Failure - Environmental Sensor An error was detected in the Environmental Sensor (Temperature/ Humidity Sensor). The sensor detects a temperature or humidity anomaly. • 92-660-00 Print speed reduced due to internal temperature • 92-661-00 Engine Sensor Failure • 92-662-00 Overheat Failure
Remedy: 1 Test the Environmental Sensor using dc140 Analog Monitor. Temperature and Humidity readings are within ranges. Go to Step 2. Go to Step 3. 2 Cycle system power. Does the error persist? Go to Step 3 Complete. 3 Check P/J17 on the MCU Board and P/J106 on the Procon Assy. The connections are secure. Go to Step 4. Secure the connections. 4 Check continuity of the Erase/Exit Harness between P/J106 and PJ16 on the MCU Board. The harness in undamaged. Go to Step 5. Replace the harness. 5 Check for 5V at P/J16-10 on the MCU Board. Is 5V available at P/J16-10 when the Front Interlock Switch is closed? Go to Step 8. Go to Step 6. 6 Check for 5V at P/J24-17 on the MCU Board. Is 5V available at P/J24-17 when the Front Interlock Switch is closed? Replace the MCU Board. Go to Step 7. 7 Check continuity of the LVPS Harness between P/J308 and PJ24 on the MCU Board. The harness in undamaged. Replace the LVPS. Replace the harness. 8 Remove the Procon Assy and check continuity of the CTD/ Hum harness between P/J106 and P/J213 at the sensor. The harness is undamaged. Replace the Environmental Sensor. Replace the harness. 9 If the error persists, replace these components, in order, until the error is resolved. 1. Environmental Sensor, PL5.3.15 2. Procon Assy, PL 5.3.1 3.MCU Board, PL10.2.18