Description: Engine Sensor Failure - Mode Switching Sensors A failure was detected in the Black (K) or FC (Full Color CMY) Switching Sensor. • 92-661-00 Engine Sensor Failure
Causes: • Transfer Belt, PL5.1.1 • Imaging Unit Link Drive, PL9.2.98 • Switching Sensor Assy, PL9.2.1 • MCU Board, PL10.2.18 • Harness RH/ MOT, PL11.2.3 • Harness CRUM/ DISP, PL11.2.4
Remedy: 1 Replace the Transfer Belt and cycle system power. Does the error persist? Go to Step 2. Complete. 2 Check guide link operation. Does the link slide smoothly back and forth between the Switching Sensors? Go to Step 3. Reseat or replace the Imaging Unit Link Drive. 3 Test the Black Switching Sensor using dc330 (93-017). The sensor signal changes (On/Off). Go to Step 8. Go to Step 4. 4 Check continuity of the RH/MOT harness between P/J9 on the MCU Board and P/J200 at the sensor. The harness is undamaged. Go to Step 5. Replace the harness. 5 Check for 3.3V at P/J9-16 on the MCU Board. Is 3.3 V available at P/J9-16? Replace the Black Switching Sensor. Go to Step 6. 6 Check for 3.3V at P/J24-4 on the MCU Board. Is 3.3V available at P/J24-4 when the Front Interlock Switch is closed? Replace the MCU Board. Go to Step 7. 7 Check continuity of the LVPS Harness between P/J308 and PJ24 on the MCU Board. The harness in undamaged. Replace the LVPS. Replace the harness. 8 Test the Color Switching Sensor using dc330 (93-018). The sensor signal changes (On/Off). Go to Step 13. Go to Step 9. 9 Check continuity of the Dispense/ CRUM harness between P/J15 on the MCU Board and P/J201 at the sensor. The harness is undamaged. Go to Step 10. Replace the harness. 10 Check for 3.3V at P/J15-1 on the MCU Board. Is 3.3 V available at P/J15-1? Replace the Color Switching Sensor. Go to Step 11. 11 Check for 3.3V at P/J24-4 on the MCU Board. Is 3.3V available at P/J24-4 when the Front Interlock Switch is closed? Replace the MCU Board. Go to Step 7. 12 Check continuity of the LVPS Harness between P/J308 and PJ24 on the MCU Board. The harness in undamaged. Replace the LVPS. Replace the harness. 13 If the error persists, replace these components, in order, until the error is resolved. 1. Imaging Unit Link Drive, PL9.2.98 2.MCU Board, PL10.2.18