Thương hiệu phân phối chính hãng
Giỏ hàng

Mã lỗi -03 — Xerox Phaser 7300

Code: -03

Description: Load MPT with [size*] [type*]
Remedy: 1 Ensure the correct weight and type of paper is loaded in the tray. See “Media and Tray Specifications” on page 1-16 for approved media types and weights. Go to step [2]. Load approved media and run a set of test prints through the printer. If an error still occurs, go to step [2]. 2 Verify the orientation of the paper loaded in the MPT is correct and matches the front panel and driver settings. Go to step [3]. Change the orientation of the paper. 3 Use service diagnostics to test the MPT Entrance Sensor and Actuator. Does the sensor operate correctly and does the actuator move freely? Go to step [5]. For a broken actuator, replace the MPT Pick Assembly. For a sensor, go to step [4]. 4 Check the wiring harness for damage or defects. Is the wiring harness free from defects? Replace the MPT Pick Assembly Replace the wiring harness. 5 Use service diagnostics to test the MPT OHP sensor. Does the sensor function correctly? Replace the Engine Controller Board. Go to step [6]. 6 Check the MPT OHP sensor wiring harness at the Engine Controller Board pin 5 REG connector for +5 volts Replace the MPT Pick Assembly. Replace the Engine Controller Board.

← Xem tất cả mã lỗi Xerox Phaser 7300

Đăng ký nhận bản tin Đăng ký nhận bản tin Đăng ký nhận bản tin Đăng ký nhận bản tin
Đăng ký nhận bản tin
Nhận ưu đãi sớm nhất khi chương trình diễn ra

Đăng ký nhận bản tin

Việc cho phép sử dụng cookie sẽ giúp cải thiện trải nghiệm của bạn trên trang web này. Chính sách cookie