Thương hiệu phân phối chính hãng
Giỏ hàng

Mã lỗi -04 — Xerox Phaser 7300

Code: -04

Description: Load Tray [1] [2] [3] [4] [5] with [size*] [type*]
Remedy: 1 Verify the paper loaded in the tray is the correct size and the orientation matches the front panel and driver settings. Go to step [2]. Match the orientation of the paper and settings. 2 Verify the guides in the tray are set snug against the paper loaded in the tray. Go to step [3]. Set the guides properly. 3 Swap trays (2, 3, 4 or 5) and try printing again. Note: If the error is for tray 1 you cannot swap this tray, go on. Does the problem move with the tray? Replace the tray. Go to step [4]. 4 Inspect the paper size plate on the back of the tray. Does the plate move while adjusting the tray guides? Go to step [5]. Replace the tray. 5 Use service diagnostics to test the paper size sensors. Do the sensors function correctly? Go to step [7]. Go to step [6]. 6 Check the wiring from the paper size sensing board to the Engine Controller Board or the LTA Controller Board. Is the wiring free from damage or defects? Replace the Paper Size Sensing Board. Replace the wiring harness. 7 Use service diagnostics to test the MPT OHP sensor. Does the sensor function correctly? Replace the Engine Controller Board. Go to step [8]. 8 Check the MPT OHP sensor wiring harness at the Engine Controller Board pin 5 REG connector for +5 volts Replace the MPT Pick Assembly. Replace the Engine Controller Board.

← Xem tất cả mã lỗi Xerox Phaser 7300

Đăng ký nhận bản tin Đăng ký nhận bản tin Đăng ký nhận bản tin Đăng ký nhận bản tin
Đăng ký nhận bản tin
Nhận ưu đãi sớm nhất khi chương trình diễn ra

Đăng ký nhận bản tin

Việc cho phép sử dụng cookie sẽ giúp cải thiện trải nghiệm của bạn trên trang web này. Chính sách cookie