Code: -07
Description: Close Duplex Unit
Remedy: 1 Is the Duplex Unit installed correctly and properly seated? Go to step [2]. Reseat the Duplex Unit. 2 Remove the Duplex Unit and cycle power to the printer. Does the error message still appear? Replace the Engine Controller Board. Go to step [3]. 3 Visually inspect the connector on the back of the Duplex Unit for damage. Replace the Duplex Unit. Go to step [4]. 4 Visually inspect the mating connector on the Printer Unit Chassis for damage. Replace the connector. Go to step [5]. 5 Inspect the Duplex Unit’s wiring harness. If defective, replace the wiring harness. Is the harness properly seated and free from defects? Replace the Engine Controller Board. Replace the Duplex Unit.