Thương hiệu phân phối chính hãng
Giỏ hàng

Mã lỗi -12 — Xerox Phaser 7300

Code: -12

Description: Install or Reseat [CMYK] Imaging Unit
Remedy: 1 Is the Imaging Unit installed and seated properly? Go to step [2]. Reseat the Imaging Unit. 2 If the keys are not set properly on the Imaging Units they may not seat properly. Are the keys on the side of the Imaging Units correctly set? Go to step [3]. Reset the keys properly. 3 Visually inspect the Imaging Unit Contact Assembly and springs. Are the contacts free from damage and debris? Go to step [4]. Clean or replace the Imaging Drum Contact Assembly. 4 Use service diagnostics to test the CMYK IU Sensor. Does the sensor function correctly? Replace the Engine Controller Board. Go to step [5]. 5 Verify continuity between the IU Sensor Board and the Engine Controller Board at the JODEN connector. Y pin 9 to pin 12 M pin 1 to pin 3 C pin 5 to pin 6 K pin 10 to pin 13 Replace the Engine Controller Board. Go to step [6]. 6 Check the wiring for defects and proper connection. Replace the wiring harness Replace the Back Plate Assembly.

← Xem tất cả mã lỗi Xerox Phaser 7300

Đăng ký nhận bản tin Đăng ký nhận bản tin Đăng ký nhận bản tin Đăng ký nhận bản tin
Đăng ký nhận bản tin
Nhận ưu đãi sớm nhất khi chương trình diễn ra

Đăng ký nhận bản tin

Việc cho phép sử dụng cookie sẽ giúp cải thiện trải nghiệm của bạn trên trang web này. Chính sách cookie